Genoa Wall Mounted Chrome Shower Set with Hand Shower

Installation Instructions

Length: 8-1/2″
Width: 19-1/2″
Features: Hand Shower Included, Tub Spout Included
Assembly Required: Yes
Installation Type: Wall Mount
Mounting Hardware Included: Yes
Base Plate Width: 2-3/4″
Shower Head Length: 8″
Shower Arm Included: Yes
Shower Arm Extension: 14″
Shower Head IPS: 1/2″
Shower Head Swivel: Yes
Tub Filler Spout Reach: 6-3/4″
Hand Shower Hose Length: 60″

  • 5″ – 6-1/2″ adjustable centers at the wall with 1/2″ MIP threaded fittings.
  • Adjustable shower riser allows for an adjustable overall height of 42-1/2″ – 47″.
  • Minimum/maximum height from inlet centers to top of riser: 35-3/4″ / 50-1/4″.
  • Minimum/maximum height from inlet centers to shower head: 31″ / 45-1/2″.
  • Optional wall-mounted hand shower bracket included.

Genoa Wall Mounted Chrome Shower Set with Hand Shower Genoa Wall Mounted Chrome Shower Set with Hand Shower

TOOLS AND MATERIALS:

  • Plumber’s Tape
  • Strap Wrench
  • Smooth Jaw Wrench
  • Level
  • Drill
  • Adjustable Wrench

INSTALLATION
1. Connect the diverter (5), washer (2) and sliding bar (6).
2. Connect the faucet body (1), washer (2) and diverter (5).
3. Secure the flange (3) to the shower wall with the included mounting eccentrics (4).
4. Place the washer with filter (2) in the outlet on the back of the faucet body (1) and connect the shower assembly to
the flange (3).
5. Determine and mark the mounting plate (7) location on the shower wall. Drill your mounting holes into the wall using
the screws (8) provided to determine the size of the drill bit needed. Secure the mounting plate (7) with the provided
screws.
6. Use a level to verify that the shower assembly is completely straight on all sides and secure to the mounting
plate (7).
7. Attach the hand shower (10) to the shower assembly.
8. Attach the shower head (9) to the top of the assembly and tighten with your smooth jaw wrench. Do not tighten more
than ¼ turn beyond hand tight.
9. Turn on the water supply and open the faucet valves. Check for any leaks and verify that the hot and cold supplies
are working correctly. Let the water flow through the riser pipe and shower hose for approximately 30 seconds to
clear out debris and dirt.