Installation Instructions
Hand-Held Shower
To install the hand shower’s slide bar, first, remove the water supply elbow from the slide bar by loosening the set screw underneath. Remove the brass nipple from the elbow by unthreading it.
- Thread the brass nipple into its prepared female fitting. Apply plumber’s tape or thread sealant to the threads before attaching. Tighten firmly using an adjustable wrench.
- Install the slide bar’s upper mounting bracket. The bracket will need to be installed 21 1/2″ above the water supply elbow, from center-to-center. Use the provided anchors and screws to secure the bracket to the wall.
- Tip: If drilling through tile, you must use a masonry drill bit and drill very carefully to avoid cracking the tile.
- Attach the slide bar by hanging it onto the installed mounting bracket and water supply elbow. Secure the slide bar by tightening the set screws located on the bottom of the bracket and elbow.
Attach the hand shower to the water supply elbow using the hand shower hose. Apply thread sealant or plumber’s tape to the threads before tightening. Hand tighten the connections firmly. 