Juno Verona Wall Mounted Chrome Finish Shower Set With Hand Held Shower And Triple Handle Mixer

Installation Instructions

No tools required, ½ connector fits standard-sized shower plumbing.

1. Use your hands counterclockwise to unscrew the old showerhead and removed it.
2. Take out the showerhead, make sure the shower filter is placed in the connector.
3. Ensure the showerhead full horizontal alignment wall mounted shower arm thread.
4. Use your hands clockwise to tighten showerhead.

6. (a) Tighten Connector (26) with Teflon Tape to Water Supplies.

Note: Don’t over tighten to avoid damage.

(b) Place Hand Shower Holder (38) onto Connector and fix it with Set Screws (31).

(c) According to the holes of Hand Shower Holder confirm the location of the mounting hole on the wall, Knock into the Anchor (27) and fix the Hand Shower Holder with Screw (37).

7. Tighten one side of Shower Hose (36) onto Hand Shower (39), and another onto Joint.

Note: Don’t over tighten to avoid damage.

8. When installation is complete, check all connections for leaks.

To install the tub spout, first remove the brass nipple from the spout by loosening the two set screws underneath.