Rivera Oil Rubbed Bronze LED Shower Set

INSTALLATION INSTRUCTIONS

2. (a) Cover the Escutcheon (23) onto the connector of water supplies and against wall.

(b) Tighten Wall Tube (24) to the connector of water supplies after winding Teflon Tape on it.

Note: Don’t over tighten to avoid damage.

3. Tighten the Shower Head (25) to the Walk Tube (24).

1. Pull handle outward and turn to blue sides to regulate cold water, In contrast to red to regulate hot water.

4. Cover the Escutcheon (19) onto the Body Assembly and against wall.

5. Install Handle (11) with Set Screw (12) to the Body Assembly and tighten it, then put the plug (13) into the hole on the handle.

6. (a) Tighten Connector (26) with Teflon Tape to Water Supplies.

Note: Don’t over tighten to avoid damage.

(b) Place Hand Shower Holder (38) onto Connector and fix it with Set Screws (31).

(c) According to the holes of Hand Shower Holder confirm the location of mounting hole on the wall, Knock into the Anchor (27) and fix the Hand Shower Holder with Screw (37).

7. Tighten one side of Shower Hose (36) onto Hand Shower (39), and another onto Joint.

8. When installation is complete, check all connections for leaks.