INSTALLATION GUIDE 
Before installing, read entire installation guide. Observe all local building and safety codes.
For the following installation instructions it is assumed that the water supply lines have been installed in the desired location behind the finished wall and are accessible for shower installation Unpack and inspect for any shipping damages. If you find any damages, do not install. Contact Customer Service, If you need assistance while installing your shower system, call our Customer Service number
TOOLS AND MATERIALS:
- Smooth Jaw Wrench
- Adjustable Wrench
- Silicone Thread Sealant
- Drill
- Tape Measure
- Level
INSTALLATION
1. Attach the upper wall support to the shower wall using a drill and the mounting hardware provided. Use a level to
ensure that the shower riser is perfectly straight.
2. Place thread sealant on the ½” pipe threads in the shower wall and thread on the mounting nuts. Allow sealant to
cure for 24 hours before use.
3. Attach the hot and cold valve bodies and decorative escutcheons (if included) directly to the pipe threads. Tighten
with an adjustable wrench to secure.
4. To install a hand-held shower, mount the cradle at a suitable height for the user with the hardware provided. Attach
the hose to the faucet with any rubber washers or sealing gaskets included. If your system does not feature a
hand-held shower move on to the next step.
5. Attach the shower head to the top of the riser and tighten with a smooth jaw wrench. Do not tighten more than ¼ turn
beyond hand tight.
6. Turn on the water supply and open the faucet valves. Check for any leaks and verify that the hot and cold supplies
are working correctly. Let the water flow through the riser pipe and shower hose for approximately 30 seconds to
clear out debris and dirt.
Note: If leakage occurs, tighten connections with your adjustable wrench as necessary. If problems persist, contact
Customer Service
